Automatic Glue Dispensing Robot

Automatic glue dispenser machine WPM-331-2

Pressure regulating valve: adjust the syringe’s insidepressure, the pressure adjustment range is 0.0 glue dispenser machine

  1. Pressure regulating valve: adjust the syringe’s insidepressure, the pressure adjustment range is 0.05-0.9MPa; When adjusting, first pull out the knob, turn clockwise to increase, counterclockwise to decrease, and press back to the knob after adjusting.

  2. Controller switch: The power supply in the control box is turned on or turned off.

  3. Y-axis slider: drives the substrate to move back and forth.

  4. Pressure gauge: shows the pressure after regulation.

  5. Manual glue button: press the button, the needle out of the glue; release the button, stop the glue.

  6. X-axis: Control the needle to move left and right.

  7. Z-axis: Control the needle to move up and down.

  8. Reference plate: used to place work pieces or fixtures.

  9. Y-axis: Control the reference plate to move back and forth.

  10. Base: Internal for installing electrical control systems.

  11. Reset switch: Through this switch, the running program can be paused and returned to the origin. Teaching can be programmed after the machine is reset.

  12. The fixture hanging plate, you can install the syringe or the dispensing valve, the specific program should be determined according to the process.

  13. Emergency stop button: When the button is pressed, the program is aborted and the device stops immediately.

  14. Start/Reset/Pause button: It is the system reset switch when it is turned on or after the emergency stop is released. After reset, it is the device running switch, and the running is pause